Have replaced bad 3RP1 cathode tube in my HO 10 and
tested all other tubes. Have changed the two
[EMAIL PROTECTED] capacitors.
It is working however not up to PAR. All controls
work. The current problem is that when in the
trapezoid pattern monitoring AM transmitted signal,
the horizontal width of the trapezoid doesn't
completely fill out to a symetrical point. The
horizontal position and horizontal gain pots work
except that there doesn't seem to be enough horizontal
gain to cause the trapezoid to fully display the full
signal.
I have a properly working SB 610 that shows clearly my
transmitted AM signal. The HO 10 doesn't fill out the
trapezoid symetrically to a point.
I suspect a resistor in the horizontal gain circuit
having changed value or maybe a suspect capacitor. Are
there any commonly known culprits that cause this loss
of horizontal gain? Naturally, I am lazy by nature,
and would rather "pick your brains" than use my feeble
brain. What are your thoughts based on your vast
knowledge and EXPERIENCE??? Thanks and 73, John, K5PGW
____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now.
http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
Searchable Archives: http://www.mail-archive.com/[email protected]/
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:[email protected]
To unsubscribe, send an email to [EMAIL PROTECTED] with
the word unsubscribe in the message body.
