Great info Jim... thanks so much. I'll give it a try. John WB5CW _____
From: [email protected] [mailto:[email protected]] On Behalf Of Jim Wilhite Sent: Thursday, February 19, 2009 3:25 PM To: Discussion of AM Radio in the Amateur Service Subject: Re: [AMRadio] 75A-2 power consumption It takes right at 90 volts for that rectifier to conduct. When it starts conducting the caps will start forming. If you are going to form the caps in this fashion, I would pull all other tubes and put the variac at 90 volts. wait about 5 mins and raise it to 100 volts. Put your finger on the cap to see if it is heating. If so, back it down about 5 volts and wait for the cap to cool. When it cools then start up with voltage again monitoring the temp of the cap. If it gets hot, wait for it to cool. That cap should, if it is good, form in about 20 minutes like this. If it doesn't, get a new one. If it does, check it in about a year because it probably will go bad by then. I wouldn't replace the tubes wholesale, you probably will throw away some of good tubes. If you have a signal generator you can tell pretty well how good they are by the sensitivity of the radio. If I remember right the fuse in that thing is 2 amp. With the volume turned up loud it probably will pull near 1.5 amps through the fuse, so you variac meter should show about that amount. Jim/W5JO ----- Original Message ----- On Thu, Feb 19, 2009 at 3:11 PM, John Carrington, M.D. <[email protected]> wrote: I'm wondering if I don't see any filament glow with that tube... I'm going to be tempted to bite on the Ebay ads that just replace all tubes... the set for this receiver is 69 bucks. It's real hard to see the filaments in that tube John. Wait until the room is dark and take a look... they are pretty faint.
______________________________________________________________ Our Main Website: http://www.amfone.net AMRadio mailing list Searchable Archives: http://www.mail-archive.com/[email protected]/ List Rules (must read!): http://w5ami.net/amradiofaq.html List Home: http://mailman.qth.net/mailman/listinfo/amradio Post: [email protected] To unsubscribe, send an email to [email protected] with the word unsubscribe in the message body. This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
