I would invite comments on a recent change to cabling my IC-910H with my AEA DSP-2232 TNC.
Until now, I have cabled the 910 main & sub data port sockets to the 2232 five pin din radio input port. The cable was made up using the 910 data socket 9600 bps convention. I did this in order to communicate with satellite BB services such as GO-32. Unfortunately, this convention does not support 1200 bps. I would need to swap cables in order to switch RX audio from data port pin 4 to pin 5 for 1200bps AFSK. To get around this shortcoming, I am replacing the data socket cables with a cable using ACC port to connect with 2232. Icom manual says this should work for 9600bps FM mode or 1200bps FM/SSB modes. Does anyone know whether using ACC port vs Main & Sub data sockets compromises anything? Jim K7EG _______________________________________________ Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
