Mike,
I have a spare G-5400B controller if you want to try that. To make
sure, the El works OK when wired into the AZ pins? If it still acts up,
I would look at a bad motor cap, which is in the rotor. However, you can
parallel a cap in the shack across pins E4 and E5. You could go to
Graingers and get a motor starting/running cap, like a 2MDR1 for less
than $ 10.00
I'm not sure on the difference between the 5400 and 5500, so maybe
someone on this forum can tell us if this controller would work. (It has
the DB-9 serial cable).
Let me know. And don't forget May 18th, for the DF Hunt!
tom bosscher k8tb
On 5/5/2010 7:36 PM, Michae J. Wolthuis wrote:
> I have an ongoing problem with my Elevation rotor of my g-5500 setup. It
> has been in to Yaesu who said it was fine. The controller was not sent in
> only the actual EL hardware because when I first got it this occurred right
> away when I installed my new site and the AZ rotor seemed to work fine on
> either the AZ or the EL terminals, so Yaesu determined it must be the EL
> itself, it appears maybe not.
>
>
_______________________________________________
Sent via [email protected]. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
