Hi Norm, Good question. It brings to mind another question (a second post coming).
To do it manually, I first start with the info for the satellite found at: http://www.amsat.org/amsat-new/satellites/status.php For example, under VO-52, it shows (for the Indian Transponder) Mode U/V (B) Linear Transponder (Inverting) (Indian Transponder): Operational Uplink: 435.2200 - 435.2800 MHz SSB/CW Downlink 145.9300 - 145.8700 MHz SSB/CW I read this to mean that (with no doppler) for this transponder, an uplink input frequency of 435.2200 MHz will result in a downlink frequency of 145.9300 MHz, etc., etc. I make up a small table for each satellite showing uplink and downlink frequencies across the range of frequencies. So for VO-52 (Indian Transponder), the table looks like this: Uplink Downlink ----------------------------- 435.22 MHz 145.87 MHz 435.23 MHz 145.88 MHz 435.24 MHz 145.89 MHz 435.25 MHz 145.90 MHz 435.26 MHz 145.91 MHz 435.27 MHz 145.92 MHz 435.28 MHz 145.93 MHz Of course, you can put as many entries in the table as you wish. You could have every Khz frequency in the range. I use this information as a starting point. Doppler will move the downlink receive frequency. So, for this satellite, if I hear some one calling CQ on 145.890 Mhz, I know I should start at an uplink frequency of around 435.240 Mhz and then tune around to find my downlink to match other station. _______________________________________________ Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
