Hi Andy,
The OCXO should be fine to drive either DEMI or DB6NT transverters.
On the VFC pin, they usually tune over a range 0-5v. Sometimes you can just
let them float, but it's usually better to tie them to a stable voltage
source. You really need to measure it to find out. I personally would not
let the VFC pin float.
73,
Mike, N1JEZ
AMSAT 29649
"A closed mouth gathers no feet"
----- Original Message -----
From: "Andy Brian" <[email protected]>
Subject: [amsat-bb] Re: 10Mhz ocxo
Hi,
I forgot to add the link to ebay
http://www.ebay.com/itm/Trimble-high-stability-Oscillator-OCXO-49422-C-10Mhz-/300593424944?pt=LH_DefaultDomain_0&hash=item45fcc3aa30
Thanks
regards AB
On Wed, Sep 14, 2011 at 9:25 AM, Andy Brian <[email protected]> wrote:
Hi,
I bought 10mhz OCXO Trimble from ebay and I can't find any datasheet
so I'm looking how to connect the pins VFC Vref
and if this OCXO is good enough for 10Mhz reference for transverters
maybe (like db6nt, demi).
Can I leave pins VFC and Vref not connected?
Any helps very welcome,
thanks,
regards AB
_______________________________________________
Sent via [email protected]. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
