Rupesh, I suggest setup the TS 2000 TNC in AGWPE and OnlineKISS will connect to the port in AGWPE to enable decode. Other way is to use a software TNC http://uz7.ho.ua/packetradio.htm to which Online KISS will connect to decode the data. 73 Nitin [VU3TYG]
>________________________________ > From: Rupesh Lad <[email protected]> >To: [email protected] >Sent: Friday, 18 July 2014 8:59 PM >Subject: [amsat-bb] Receiving TigriSat Satellite > > >Hello all, > >I am trying to receive TigriSat, First Iraqi satellite which have a FSK >Beacon on 435MHz frequency. I use a 2 unit array of cross Yagi antenna and >Kenwood TS2000 TRX. > >The packet sounds quite good on TS2k whereas nothing is decoded on >OnlineKISS+ ver 8.2.2 by DK3WN. The COMM port is connected to the serial >port of TRX. The internal TNC of TS2000 was set to KISS mode. On air baud >rate 9k6 and COMM port baud rate to 9k6 as expected. The COMM port also >goes green on the software screen. > >Have I miss any setting or is anything else required to decode the signals? > >-- >Regards, >Rupesh Lad >_______________________________________________ >Sent via [email protected]. Opinions expressed are those of the author. >Not an AMSAT-NA member? Join now to support the amateur satellite program! >Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb > > > _______________________________________________ Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
