I looked through the documentation for an answer to the question but was
unsuccessful.
Under Analog 3.11, if I configure with "RAWBYTES OFF" Analog reports data
transfer in "kbytes" where a "kbyte" is 1024 bytes. According to a web page
I ran accross the other day, (http://physics.nist.gov/cuu/Units/binary.html)
a "kilobyte" is 1000 bytes while a "kibibyte" is 1024 bytes.
In the current documentation it says that RAWBYTES OFF will report data
transfer in "kilobytes".
Does this indicate that Analog has switched to 1000 byte "kbytes"? I did
not notice anything on this issue in the "What's new" page.
Tristan Lawrence
------------------------------------------------------------------------
This is the analog-help mailing list. To unsubscribe from this
mailing list, send mail to [EMAIL PROTECTED]
with "unsubscribe" in the main BODY OF THE MESSAGE.
List archived at http://www.mail-archive.com/[email protected]/
------------------------------------------------------------------------
