Hi All This is Vinod from India, We are trying to port the Accessory protocol from the Arduino ADK to a Freescale iMX35 board, We are using beagle board as Android powered device and the baegle board has been ported with Android 2.3.4 that supports accessory mode(We are using the pre- built android image from TI for Beagle board).
We am using libusb-1.0 for implementing USB driver to communicate with phone on the accessory. When the beagle board(Android powered device) is connected to the Accessory(PC/iMx35) the accessory will read the VID and PID. When the accessory is trying to switch the android powered device(In this case beagle board) to accessory mode by getting protocol by sending vendor specific command and the request type = 51, the response from the android device is that command is not supported by the Android powered device(getting -9 as response to the libusb_control_transfer()). Should we enable some service in the Android 2.3.4 to support accessory? I am not able to proceed furhter any help is highly appreciated. Many thanks and Best regards, Vinod Bhargav B S -- You received this message because you are subscribed to the Google Groups "Android Developers" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/android-developers?hl=en
