Dear all, I am running android on beagle board which is built from source via NFS mounting.
My linux host machine ip setting is 10.7.143.3. my bootargs is console=ttyS2,115200n8 root=/dev/nfs rw nfsroot=10.7.143.3:/root/ harish_work/Beagle/android_FS ip=10.7.143.5::255.0.0.0 nolock,rsize=1024,wsize=1024 rootdelay=2 video=omapfb:mode:1024x...@60 init=/init when booting up the beagle board, it prints following messages, eth0: link up, 100Mbps, full-duplex, lpa 0x45E1 IP-Config: Guessing netmask 255.0.0.0 IP-Config: Gateway not on directly connected network. Waiting 2sec before mounting root device... Looking up port of RPC 100003/2 on 10.7.143.3 Looking up port of RPC 100005/1 on 10.7.143.3 VFS: Mounted root (nfs filesystem). Freeing init memory: 156K Warning: unable to open an initial console. init: cannot open '/initlogo.rle' sh: can't access tty; job control turned off # FAT: bogus number of reserved sectors VFS: Can't find a valid FAT filesystem on dev mmcblk0. warning: `rild' uses 32-bit capabilities (legacy support in use) 1) what's the error -> sh: can't access tty; job control turned off 2) how to provide initab in android file system. 3) how to set dns? I tried from wiki, #setprop net.eth0.dns1 XX.XX.XX.XX Then, when i tried to ping, # ping google.com ping: unknown host google.com But i can ping my LAN ip (10.7.143.3), my beagle board ip is 10.7.143.5. How to fix this. Regards, HarishKumar.V --~--~---------~--~----~------------~-------~--~----~ unsubscribe: [email protected] website: http://groups.google.com/group/android-porting -~----------~----~----~----~------~----~------~--~---
