Hi: After following the threads on this forum, I have setup a build environment on Ubuntu 8.10.
I have successfully done the repo sync, and compiled an image, which I use with the make-live script to test on my Aspire-One. So far so good. I also managed to enable VESA_FB, and remove PMEM etc., and actually the Android GUI boots up fine on the Aspire-One. Even better. Now, I am trying to enable the WiFi card on the Aspire One, which I know is a ATH5K. So, I did a 'make menuconfig' again, enabled the Atheros card as part of the kernel rather than a module, and compiled bzImage, which amazingly (for this noob) compiles correctly. Then I moved the bzImage to the vendor/asus/eee_701 directory as suggested in the forum. I do the compile for installer_img again - but the process comes back within a few seconds saying "Nothing to be done for installer_img" Where am I going wrong? The first time this happened, I did a make clean (with target set as x86) and it removed everything under out/. After that when I did the compile again, it took a long time and completed. I am trying to find out if there is a way to do this in a shorter time to incorporate just the new bzImage, rather than compile everything again? I am sure I have left out a detail or two up there in asking a question - give the noob a break... Regards, Gani --~--~---------~--~----~------------~-------~--~----~ unsubscribe: [email protected] website: http://groups.google.com/group/android-porting -~----------~----~----~----~------~----~------~--~---
