I ve created the uImage of the Android kernel,and loaded that into the boot partition of the SD card and the Android_RFS i m accessing via nfs.But this is message i get when i load the kernel onto the OMAP 3530 board....How to proceed?
Texas Instruments X-Loader 1.41 Detected Samsung MuxOneNAND1G Flash Starting OS Bootloader... U-Boot 1.1.4 (Sep 25 2008 - 20:16:32) OMAP3-GP rev 2, CPU-OPP2 L3-165MHz OMAP3EVM 1.0 Version + mPOP (Boot ONND) DRAM: 128 MB OneNAND Manufacturer: Samsung (0xec) Muxed OneNAND 128MB 1.8V 16-bit (0x30) OneNAND version = 0x0221 Scanning device for bad blocks num of blocks = 1024 onenand_wait: controller error = 0x2400 Bad factory block98 at 0x00c40000 In: serial Out: serial Err: serial Reseting CHIP... Done LAN9x18 (0x01150002) detected. Setting mac address: aa:bb:cc:dd:ee:ff start Auto negotiation... (take ~2sec) Auto negotiation complete, 100BaseTX, full duplex Hit any key to stop autoboot: 0 2039024 bytes read ** Unable to read "ramdisk.gz" from mmc 0:1 ** ## Booting image at 80000000 ... Image Name: Linux-2.6.29-omap1 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2038960 Bytes = 1.9 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK OK Starting kernel ... --~--~---------~--~----~------------~-------~--~----~ unsubscribe: [email protected] website: http://groups.google.com/group/android-porting -~----------~----~----~----~------~----~------~--~---
