On 15-04-02 09:18 AM, Mark Hatle wrote:
On 4/1/15 5:17 PM, Cliff Brake wrote:

I'm getting the following when running populate_sdk with a dizzy build.

Angstrom distro
workstation OS is debian wheezy
gcc (Debian 4.7.2-5) 4.7.2

Any thoughts what I'm doing wrong?


NOTE: Preparing runqueue
NOTE: Executing SetScene Tasks
NOTE: Executing RunQueue Tasks
ERROR: Function failed: do_configure (log file is located at
ERROR: Logfile of failure stored in:
Log data follows:
| DEBUG: Executing python function sysroot_cleansstate
| DEBUG: Python function sysroot_cleansstate finished
| DEBUG: SITE files ['endian-little', 'common-linux', 'common-glibc',
'bit-64', 'x86_64-linux', 'common']
| DEBUG: Executing shell function autotools_preconfigure
| DEBUG: Shell function autotools_preconfigure finished
| DEBUG: Executing python function autotools_copy_aclocals
| DEBUG: Python function autotools_copy_aclocals finished
| DEBUG: Executing python function gcc_multilib_setup
| DEBUG: Python function gcc_multilib_setup finished
| DEBUG: Executing shell function do_configure
| cat: 
No such file or directory
exit 1 from
|   grep -v "\#endif.*GCC_DEFAULTS_H" >
| ERROR: Function failed: do_configure (log file is located at
The above lines are the actual failure.  The failure was in configuring the
recipe 'gcc-cross-initial-x86_64'.

I do not know the caue of the failure, but the issue is obvious enough, it was
trying to load the 'defaults.h' file and modify a few settings in it.

The code in question is in 'meta/recipes-devtools/gcc/gcc-configure-common.inc':

I noted the exact same problem/error over on the Angstrom mailing list, I'll know next time to check here too :-)

What I noticed is that I don't see the problem when my DISTRO is "poky" or "nodistro", it also doesn't seem to be affected by using the Linaro toolchain or not. I believe it is "angstrom-next" and "angstrom-v2013.12" related.

Angstrom-distro-devel mailing list

Reply via email to