I my case, I had to bring the usb0 down because the route was going there first.
if you do route -n, you should be able to see where it is going. I just did "ifconfig usb0 down" as suggested here: http://dab.free.fr/wp/?p=62 (French) and everything worked fine after that. Cheers, Bernard ----- Original Message ---- From: Yan Seiner <[EMAIL PROTECTED]> To: [EMAIL PROTECTED]; [email protected] Sent: Sunday, March 2, 2008 5:36:33 AM Subject: [Angstrom-distro-users] Card associates, but fails to send any data I am trying to get a Marvell 8385 cf card running on a Sharp Zaurus. I have the card set up, I've built the firmware, and the card connects and associates with the AP just fine. But.... Absolutely no data flows. No pings, no dhcp broadcasts, nothing. Both lights are lit up, and both blink like crazy when the card is associating, but once it's connected no blinkenlights. I'm stuck at this point. I've looked at tcpdump on the AP, and there is nothing coming in from this card. I've assigned IP and route manually, again, no joy. I'm running 2.6.24-rp from Angstrom. I would appreciate any suggestions on this. --Yan _______________________________________________ Angstrom-distro-users mailing list [email protected] http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-users Ask a question on any topic and get answers from real people. Go to Yahoo! Answers and share what you know at http://ca.answers.yahoo.com _______________________________________________ Angstrom-distro-users mailing list [email protected] http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-users
