thanks, i'll try that.
-mez
----- Original Message -----
From: "Erik Hatcher" <[EMAIL PROTECTED]>
To: "Ant Users List" <[EMAIL PROTECTED]>
Sent: Sunday, January 13, 2002 11:24 AM
Subject: Re: junit jvmarg
> To pass parameters, use <sysparameter>, not <jvmarg>.
>
> And then in your test case use System.getParameter("param_name")
>
> You will have to refactor your code a bit to adjust it from being a
> command-line run test case to being one from <junit>, which does not go
> through 'main'. But you could adjust your command-line section to use
> system properties too, and then use java -Dname=val to set parameters -
then
> both ways would have the same parameter accepting mechanism.
>
> Erik
>
>
> ----- Original Message -----
> From: "Marcus" <[EMAIL PROTECTED]>
> To: "Ant Users List" <[EMAIL PROTECTED]>
> Sent: Sunday, January 13, 2002 2:16 PM
> Subject: junit jvmarg
>
>
>
> I am trying to pass some parameters for my unit test and junit reports and
> error.
> Here is the code I am using:
> <junit printsummary="yes" fork="yes" haltonfailure="yes">
> <jvmarg value="${my.test.TestCase}"/> <jvmarg value="some
> parameter"/> <jvmarg value="some parameter"/> <jvmarg value="some
> parameter"/> <jvmarg value="some parameter"/> <jvmarg value="some
> parameter"/> <jvmarg value="some parameter"/>
> <formatter type="plain" />
> <test name="my.test.TestCase" />
> </junit>
>
> Where my.test.TestCase needs 6 parameters to run with java
my.test.TestCase
> param1 param1
> param3 param4 param5 param6
> The above is not right and I was wondering if someone had run junit
> with a test case that needs parameters passed for the unit test to run?
> -mez
>
>
>
>
>
>
> --
> To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]>
> For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>
>
>
--
To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]>
For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>
