Re: Can I switch of "echo" string from Echo task

[Erik Hatcher]

Thats beyond the responsibility of the <echo> task. Thats the default logger putting the task name as a prefix to all output logged. You can use the NoBannerLogger or -emacs as previously mentioned. Or write a custom logger that has a special case for <echo> output perhaps.

Erik


Janusz Dalecki (TYCO) wrote:

Actually when I use echo task like this:
		<echo message="Hello"/>
... it will print on the console string like this:
		[echo] Hello
... and I would like to switch off the "echo" string so I could see only
this:
		Hello

Janusz
-----Original Message-----
From: Erik Hatcher [mailto:[EMAIL PROTECTED]]
Sent: Thursday, 28 November 2002 10:57 AM
To: Ant Users List
Subject: Re: Can I switch of "echo" string from Echo task


You mean switch "off" the echo output?

Try echoing to a different level, such as verbose.  <echo
level="verbose">blah blah</echo>

Then you will only see that output if you run with -verbose.

	Erik


Janusz Dalecki (TYCO) wrote:

I would like to switch of "echo" string when I am executing “Echo” task.

Is

it possible?

Janusz

--
To unsubscribe, e-mail:   <mailto:[EMAIL PROTECTED]>
For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>


--
To unsubscribe, e-mail:   <mailto:[EMAIL PROTECTED]>
For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>

--
To unsubscribe, e-mail:   <mailto:[EMAIL PROTECTED]>
For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>