Mark,
When I installed 1.60b1, I used the manual configuration in SETUP.BAT with a
printout of my ARACHNE.CFG from 1.48 as a guide. I accepted most of the
defaults except those that I *knew* had to be changed. I started 1.60 and
got the fatal error, "PPP not found." I went back into ARACHNE.CFG and made
a slight change to my login script and then changed "IP_Address PPP" in the
[tcp/ip] section to "IP_Address %MYIP%" and Arachne started working like a
charm. No real problems since then.
Hope this helps.
Roger Turk
Tucson, Arizona
Mark David Roth wrote:
>> ... Then it took me to thge dial screen, where I clicked on the connect
button. MINITERM 1.40 connected at 115200 and the following message appeared:
Terminal mode, Press <Alt+P> or <F7> to exit and try PPP (SLIP). After 2
minutes I got a NO CARRIER message. The same thing happened on all my previous
installations of versions of 2Arachne. After 17 minutes I pressed <F7> and got
the same message I always do: PPP link is down driver not installed. then it
took me to the error screen system\gui\err-ppp.ah. ...<<
