Thank you for help, but it still wont work. Opie does nothing. The Konqueror still is empty. Now i have to look for a method to check what happens on opie.
thanks for help toni 2007/6/28, Thomas Bächler <[EMAIL PROTECTED]>: > Anton Achatz schrieb: > > first i have loaded the module "usbnet" > > modprobe usbnet > > > > then > > ifconfig usb0 192.168.0.202 > > > > then > > route add -host 192.168.0.200 usb0 > > > > ping 192.168.0.202 answers ok. > > > > > > So now i have to enable the NAT support in archlinux, but how? > > > > I tried to enable via > > /proc/sys/net/ipv4/ip_forward = 1 > > > > and also tried edit > > /etc/sysctl.conf and set 1 to the net.ipv4.ip_forward > > (net.ipv4.ip_forward=1) > > iptables -t nat -A POSTROUTING -s 192.168.0.200 -o ppp0 -j MASQUERADE > > Replace ppp0 with your outgoing interface, like eth0 or so. Now on your > usb device, set 192.168.0.202 as default route and use the DNS from your > /etc/resolv.conf. > > You still need the ip_forward setting! Use /etc/rc.d/iptables save to > save the iptables rules and add 'iptables' to your rc.conf to set them > at boot time. > > A short introduction to iptables can be found here: > http://wiki.archlinux.org/index.php/Simple_stateful_firewall_HOWTO > > > _______________________________________________ > arch mailing list > [email protected] > http://archlinux.org/mailman/listinfo/arch > > > _______________________________________________ arch mailing list [email protected] http://archlinux.org/mailman/listinfo/arch
