We recently bought the 6230 for ILL.  Here's their settings.

The settings under Documents/Scan don't stick unless you set them in 
Preferences.  Under Settings/Preferences/Scan Tab, select your scanner, set 
Twain.  Our settings are 600 resolution, b/w, dither pattern 0 (zero), 
brightness/contrast slider halfway, high quality/slow speed, scan/send 
disposition.  Once these are saved, they should stick.

I got these settings from out ILL Dept.  I hope they make sense.



Craighton Hippenhammer
Associate Professor
Department of Library Informatics
Benner Library & Resource Center
Olivet Nazarene University
Bourbonnais, IL 60914
[email protected]


>>> Bruce Deitz <[email protected]> 3/24/2009 8:22 AM >>>
We recently purchased the Fujitsu 6230 scanner.

Three questions:

1.  Is ISIS needed to operate the scanner.  
    Twain driver in place.
    Our previous scanner was using ISIS, not twain.

2.  When we use the flatbed the document is too light.
     We have to select more, select scan, then increase
     the brightness to make the document readable.

Is there a fix? Or does every document require this procedure?

3.  Also, the paper feeder does not feed multiple pages.
    When we insert the page through the feeder, it too 
    is too light to read.  We have to select more, select scan,
    then adjust increase the brightness to make the document 
    readable. 

Is there a fix?  Any help greatly appreciated.


_______________________________________________
ARIE-L mailing list
Mail the list at [email protected]
Unsubscribe at http://www.arie-l.org#subscribers
Archive at http://www.mail-archive.com/[email protected]/

Reply via email to