--- crowd-funded eco-conscious hardware: https://www.crowdsupply.com/eoma68
On Sun, Jul 23, 2017 at 6:53 PM, Joseph Lira <[email protected]> wrote: > Hello > > From your last update I havent seen an update as to how the os will be > delivered/installed can you give an update? Will it be an SD card? Also when > do you plan to start shipping boards the crowdfunding says nov of this year > is that still correct? Im asking becuase i wanted to use the eoma68 to be a > little low power stream box actually can this be done? Or i wanted to replace > my original pi that runs pi-hole hi eric these are answered by the last updates, the answers don't change, they're not time-dependent, they're "goal" dependent, where the goals are in turn dependent on *other people* completing certain tasks. so it's flat-out impossible to answer any question that starts with "when" :) there's no NAND any more so micro-sd card it is. i asked for some help from people about how and what to ship... no response. 2,500 people and nobody made any off-the-wall suggestions: i must have asked in an unclear way. (p.s. thank you to the person who suggested places to look for low-cost micro-sd cards). i've been in 3D design head-space for almost a month, it's... "deep rabbit-hole" territory.... driving me nuts but finally the last batch of critical parts are arriving tomorrow, i'll be able to start assembly of the experimental 3D printer. near-100%-focus on that is why i've not been talking much. http://forum.openscad.org/ANN-pyopenscad-spline-surface-generator-td21838.html i reaally meant "deep down the rabbit hole" stuff... :) some fantastic shapes just completed tonight, a very exotic fan duct which takes twin 25mm fans from the *top* of the carriage holder, goes through twin ducts made from spiined "legs" that morph from squares to crescent moon shapes, which are joined back-to-back to create the outer and inner circle surrounding the extruder hot-end. a hollow arc-sphere duct is dropped on top of that and vanes added to create vortices but also act as duct support. if you've seen the mendel90 fan duct the effeect is a bit like that but without the "support" problems (due to the vanes). i wanted the air to come out evenly all the way round the extruder but i also want to try it as a vortex ("tornado"). overall it's a fascinating and beautiful shape, in a startling and exotic way. > I been very temped to buy a new raspberry pi 3 for streaming or a tiny intel > nuc to do the same, but i held of because i truly want to support your project thanks eric, really appreciated. _______________________________________________ arm-netbook mailing list [email protected] http://lists.phcomp.co.uk/mailman/listinfo/arm-netbook Send large attachments to [email protected]
