I will try my 2.5 amp power supply tonight. If I still see the same problems I will go ahead and respond back to the same email. On Wed, Feb 1, 2017 at 11:41 AM Winfried de Heiden <[email protected]> wrote:
> Hi all, > > Double checked: 2.5A power supply. > Winfried > > Op 01-02-17 om 13:58 schreef Winfried de Heiden: > > Hi all, > > I don't know by head but it should be enough; it worked for weeks and it > is sold as "the official PI power supply". > > I'll check tonight to be shure. > > Winfried > > -----Oorspronkelijke bericht----- > > *Datum*: Wed, 1 Feb 2017 11:27:45 +0000 > *Onderwerp*: [fedora-arm] Re: Raspberry PI 3 locking up > *Cc*: [email protected], Rafael Leiva-Ochoa <[email protected] > <rafael%20leiva-ochoa%20%[email protected]%3e>> > *Aan*: Winfried de Heiden <[email protected] > <winfried%20de%20heiden%20%[email protected]%3e>> > *Van*: Peter Robinson <[email protected] > <peter%20robinson%20%[email protected]%3e>> > > On Wed, Feb 1, 2017 at 7:52 AM, Winfried de Heiden <[email protected]> wrote: > > > Hi all, > > Same for me, since a couple of days the Rapsbery Pi 3 suddenly stops. One or > two time I was quick enough to catch a kernel panic on the screen. > > Looks like a kernel thing to me. I moved the SD-card to my " old" Raspberry > Pi 2 (two), the same installation is running fine for a couple of days. > > > > What is the AMP rating of your power supplies? > > > > Screen shot of the kernel panic attached. I think I' ll create a bugzilla on > this. > > Winfried > > > > Op wo, 1 feb 2017 om 1:26 , schreef Rafael Leiva-Ochoa <[email protected]>: > > Hi Everyone, > > I've been running a raspberry pi 3 with Fedora release 25 (Twenty Five) > using kernal 4.9.6-200.fc25.armv7hl, and I have been noticing for the last 2 > weeks that my Pi locks up. I tried hooking it up to an HDMI monitor, and USB > keyboard to see if the system generates any message, but I only get a blank > screen and no reaction from the keyboard. I have looked at the > /var/log/message, and dmesg, and I don't see anything that could be causing > the problem. I was thinking it could be overheating, but Fedara 25 does not > support any of the rasbian commands to run heat sensor checks. > > Any ideas? > > Thanks, > > Rafael > > > _______________________________________________ > arm mailing list -- [email protected] > To unsubscribe send an email to [email protected] > > > _______________________________________________ > arm mailing list -- [email protected] > To unsubscribe send an email to [email protected] > > > > _______________________________________________ > arm mailing list -- [email protected] > To unsubscribe send an email to [email protected] > > >
_______________________________________________ arm mailing list -- [email protected] To unsubscribe send an email to [email protected]
