Hi. I have hopefully an easy question but has anyone gotten Fedora 27 aarch64
to work on the Pine Rock64 (https://www.pine64.org/?page_id=7147)? I installed
the image using the instructions at
https://fedoraproject.org/wiki/Architectures/AArch64/F27/Installation.
Specifically I made sure to set --target=pine64_plus. The image I pulled was
from https://alt.fedoraproject.org/alt/ and was the minimal image. Based on
this
(https://nullr0ute.com/2017/11/overview-of-aarch64-sbc-support-in-fedora-27/) I
saw that a serial connection was required but unfortunately I can't seem to get
that piece to work. I did also flash an Ubuntu image just to make sure I had
the jumpers correct for the serial connection and that did work as expected. I
also made sure to set enable_uart=1 in config.txt. Any thoughts would be
greatly appreciated :)
_______________________________________________
arm mailing list -- [email protected]
To unsubscribe send an email to [email protected]
