Hi Peter - My apologies about getting your name wrong. :/ Thank you very much for your help - this project is for the Bristol Public library, so you are not just helping me, you are helping the community of Bristol TN/VA. :)
Thanks again, Garry Wakely On Fri, Oct 18, 2019 at 5:17 AM Peter Robinson <[email protected]> wrote: > Please leave the Arm list on the replies. > > My name is Peter. > > I've emailed the sugar list to see if they're aware of the F-31 > problem and asked them to resolve it if so. > > Peter > > > Hi Paul - Thank you very much for the suggestion to move to the 31 > pre-release. It is getting us much closer, but not all the way there yet. > > With the 31 pre-release, installed following the same directions as > earlier in this thread, the system boots up, asks for an Admin name and > password, user name and password, finishes configuration, then goes to the > login page. Upon entering the login information, the system reboots > itself. :/ So close! > > > > Does there happen to be a stable 29 release for the Pi 3b+ ? I could > not find it in numerous searches today. > > > > Thanks again, > > > > Garry Wakely > > > > > > On Wed, Oct 16, 2019 at 5:48 PM Peter Robinson <[email protected]> > wrote: > >> > >> Adding back Arm list. > >> > >> On Wed, Oct 16, 2019 at 8:01 PM Garry Wakely <[email protected]> > wrote: > >> > > >> > Hi Peter - It is the Fedora-SoaS-armhfp-30-1.2-sda version downloaded > this morning from here: https://arm.fedoraproject.org/ > >> > It was installed according to the directions here: > https://docs.fedoraproject.org/en-US/fedora/f30/install-guide/install/Preparing_for_Installation/#sect-preparing-boot-media > >> > and installed using the Fedora Media Writer. > >> > >> There was a known issue with the F-30 release. I would give one of the > >> F-31 pre-releases out as I believe they should be much better. > >> > >> >> > >> >> > Hi Folks - I am trying to set up Sugar On A Stick for Raspberry Pi > 3+, but am running into a boot issue. The boot process runs properly until > it gets to "Reached Target Basic System", and then it hangs at > >> >> > "A start job is running for dev/dis...1fe03C48" at which point > there is no further progress. Has anyone else had a problem like this, and > if so, what is your workaround/solution? > >> >> > >> >> What release? >
_______________________________________________ arm mailing list -- [email protected] To unsubscribe send an email to [email protected] Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/[email protected]
