> -----Original Message----- > From: Cyrus <[email protected]> > Sent: 16 December 2021 14:52 > To: Guillaume Gardet <[email protected]> > Cc: [email protected]; nd <[email protected]> > Subject: Re: Dell Wyse > > El jue, 16 dic 2021 a las 9:50, Cyrus (<[email protected]>) escribió: > > > > El jue, 16 dic 2021 a las 5:08, Guillaume Gardet > > (<[email protected]>) escribió: > > > > > > Hi, > > > > > > > -----Original Message----- > > > > From: Cyrus <[email protected]> > > > > Sent: 15 December 2021 19:28 > > > > To: Guillaume Gardet <[email protected]> > > > > Cc: [email protected]; nd <[email protected]> > > > > Subject: Re: Dell Wyse > > > > > > > > Good afternoon, > > > > > > > > I had a year-long lapsus on this topic. Given there are no device > > > > specific images in this case at > > > > http://download.opensuse.org/ports/armv7hl/distribution/leap/15.2/ > > > > appliances > > > > /, > > > > which image should I try?. > > > > > > I would not recommend Leap 15.2 which is going EOL at the end of the > > > month. > > > You can try : > > > * Leap 15.3: > > > http://download.opensuse.org/ports/armv7hl/distribution/leap/15.3/ap > > > pliances/openSUSE-Leap-15.3-ARM-JeOS-efi.armv7l.raw.xz > > > * Tumbleweed: > > > https://download.opensuse.org/ports/armv7hl/tumbleweed/appliances/op > > > enSUSE-Tumbleweed-ARM-JeOS-efi.armv7l.raw.xz > > > > > > This may work, if a UEFI firmware is flashed on the system. > > > > > > Cheers, > > > Guillaume > > > > > Good morning! > > > > I will go with 15.3. Unluckily UEFI doesn't seem an option. From what > > I found, options are WLoader or "Open Firmware" (which is presented as > > "provides better Device Tree support than WLoader"). > > > > I understand JeOS is the lighter option, would it be OK to go with it > > and afterwards install any software needed (even going with > > KDE/GNome)?, my use case would be to run those little boxes as VMware > > Horizon clients or kiosks machines. > > > > Regards, > > CI.- > > Oh, can I assume these images are "installed & ready to boot" images and not > installers (meaning I need to find a way to get them to the internal storage > of the > board/appliance)?
Indeed, that is it. Guillaume > > Regards, > CI.-
