El 2022-04-16 10:56, Stefan Seyfried escribió:
On 15.04.22 23:24, Oscar wrote:
Hi,
My UdooQuad board needs some extra modules added to initrd in order to
boot (currently it hangs).
specify "modules".
Kernel modules or dracut modules?
Ooops, I meant kernel modules, sorry!
How can I add additional modules to the initrd with dracut and kiwi?
Is there any board that needs this too that I can check?
Dracut modules:
create a file /etc/dracut.conf.d/my_dracutmodule.conf that contains
add_dracutmodules+=" my_xyz_dracutmodule "
Kernel modules:
create a file /etc/dracut.conf.d/my_kernelmodule.conf that contains
drivers+=" my_kernelmodule "
Of course they can both go into the same file.
Note that the blanks at the beginning and the end of the "+=" string
are important.
Thanks Stefan. After adding more than 100 kernel modules to the initrd
without luck, I have come to the conclusion that the problem is located
in the dtb file as using the dtb file from Armbian project with the JeOS
image the board boots fine :)
Welcome to openSUSE Tumbleweed 20220419 - Kernel 5.17.3-1-default
(ttymxc1).
localhost login:
Any clue on how can I debug DTB issues? I suspect of the mmc config but
I don't know where to start.
TIA
Have fun,
