Hey there, has anyone managed to run a Leap/Tumbleweed installation on a Raspberry 4 Compute Module yet?
I have a Raspberry 4 CM (8GB/noWifi/noEMMC) and a Mini Base Board [1]. My setup is to boot the installation ISO from SD-Card and then install the System on the NVME disk attached to the board. However I cannot get the USB and network to run within the installer. In Grub the USB keyboard works fine, however once the YaST installer comes up, neither the network interface nor any USB devices work. Multiple resources explain that by default the USB 2 ports are disabled by default [2-4]. The solution is to set some custom parameters in /boot/config.txt: dtoverlay=dwc2,dr_mode=host I wonder how I can do this while booting from an ISO and not from an image. I played around with different kernel parameters but so far no luck. Also ssh and/or VNC installation is not possible, because the network is not coming up either. Anyone a good idea how to advance from here? Best, Felix [1] https://www.waveshare.com/cm4-io-base-a.htm [2] https://www.jeffgeerling.com/blog/2020/usb-20-ports-not-working-on-compute-module-4-check-your-overlays [3] https://www.pcguide.com/raspberry-pi/how-to/set-up-compute-module-4-cm4/ [4] https://forums.raspberrypi.com/viewtopic.php?t=309755
signature.asc
Description: This is a digitally signed message part
