I used dd in linux to copy the snapshot to a microSD. Then booted with that card.
I then did the exact same procedure with 5.9 release using the same card. That one boots normally (but is not able to install on the internal memory of the BBB). On Sun, Aug 14, 2016 at 4:07 PM, Jonathan Gray <[email protected]> wrote: > On Sat, Aug 13, 2016 at 02:57:39PM +0200, Farid Joubbi wrote: > > Hello, > > > > Lately I have not been able to boot the current snapshots at all with my > > bbb. > > This is what I get with the snapshot from 12th of August: > > > > U-Boot SPL 2016.07 (Aug 05 2016 - 23:28:55) > > Trying to boot from MMC1 > > ** First descriptor is NOT a primary desc on 0:1 ** > > MMC partition switch failed > > *** Warning - MMC partition switch failed, using default environment > > > > ** Partition 1 not valid on device 0 ** > > spl_register_fat_device: fat register err - -1 > > spl_load_image_fat: error reading image u-boot.img, err - -1 > > MMC partition switch failed > > *** Warning - MMC partition switch failed, using default environment > > > > spl: no partition table found > > SPL: failed to boot from all boot devices > > ### ERROR ### Please RESET the board ### > > > > > > What is going on? > > Did you remove the fat partition created by the installer when > partitioning? > >
