Hello arm@, Peter J. Philipp kindly donated me a Banana PI R1 to test, I have successfully installed OpenBSD-current. Wifi works fine even without connecting the antennas, ethernet dwge0 is detected but it does not work.
I have tried running dhclient without success, and also setting an IP manually, in this case I can ping that IP but doing a ping to the router does not work. WAN port has a permanent green light, and when I connect the cable another orange light appears. I have tried also connecting the cable to a LAN port without success. This happens in the 28/Sept and 30/Sept snapshots. I have not tried previous ones. # dhclient dwge0 dwge0: no link ........... sleeping ifconfig: dwge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 lladdr 02:d7:08:00:d0:8b index 1 priority 0 llprio 3 media: Ethernet autoselect (none) status: no carrier dmesg: OpenBSD 6.0-current (GENERIC) #60: Thu Sep 29 22:49:03 MDT 2016 dera...@armv7.openbsd.org:/usr/src/sys/arch/armv7/compile/GENERIC real mem = 1073741824 (1024MB) avail mem = 1044459520 (996MB) mainbus0 at root: Lamobo R1 cpu0 at mainbus0: ARM Cortex A7 rev 4 (ARMv7 core) cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled cpu0: 32KB(32b/l,2way) I-cache, 32KB(64b/l,4way) wr-back D-cache cortex0 at mainbus0 sunxi0 at mainbus0 sxipio0 at sunxi0: 175 pins sxiccmu0 at sunxi0 gpio0 at sxipio0: 18 pins gpio1 at sxipio0: 24 pins gpio2 at sxipio0: 25 pins gpio3 at sxipio0: 28 pins gpio4 at sxipio0: 12 pins gpio5 at sxipio0: 6 pins gpio6 at sxipio0: 12 pins gpio7 at sxipio0: 28 pins gpio8 at sxipio0: 22 pins agtimer0 at mainbus0: tick rate 24000 KHz simplebus0 at mainbus0: "soc" sximmc0 at simplebus0 sdmmc0 at sximmc0: 4-bit, sd high-speed, mmc high-speed, dma ehci0 at simplebus0 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 configuration 1 interface 0 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1 sxiahci0 at simplebus0: AHCI 1.1 scsibus0 at sxiahci0: 32 targets ehci1 at simplebus0 usb1 at ehci1: USB revision 2.0 uhub1 at usb1 configuration 1 interface 0 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1 sxidog0 at simplebus0 sxirtc0 at simplebus0 com0 at simplebus0: ns16550, no working fifo com0: console com1 at simplebus0: ns16550, no working fifo com2 at simplebus0: ns16550, no working fifo dwge0 at simplebus0 dwge0: Ethernet address: 02:d7:08:00:d0:7a ukphy0 at dwge0 phy 1: Generic IEEE 802.3u media interface, rev. 4: OUI 0x00d897, model 0x0032 ampintc0 at simplebus0 nirq 160 scsibus1 at sdmmc0: 2 targets, initiator 0 sd0 at scsibus1 targ 1 lun 0: <SD/MMC, 00000, 0010> SCSI2 0/direct fixed sd0: 15208MB, 512 bytes/sector, 31145984 sectors urtwn0 at uhub1 port 1 configuration 1 interface 0 "Realtek 802.11n WLAN Adapter" rev 2.00/2.00 addr 2 urtwn0: MAC/BB RTL8192CU, RF 6052 2T2R, address 28:f3:66:41:c9:cf vscsi0 at root scsibus2 at vscsi0: 256 targets softraid0 at root scsibus3 at softraid0: 256 targets boot device: sd0 root on sd0a (57401f70d81fcffe.a) swap on sd0b dump on sd0b WARNING: preposterous time in file system WARNING: CHECK AND RESET THE DATE! Thank you for this port, Francisco.