> Date: Wed, 13 Jan 2021 02:13:42 +0000 > From: tech-lists <[email protected]> > > On Wed, Jan 13, 2021 at 03:19:35PM +0000, Stuart Henderson wrote: > >Set your uefi firmware to device tree or acpi + device tree mode. > > Unfortunately neither of those modes worked. It sits at the part before it's > cleared the large raspberry image, after the first two lines of booting > output. Nothing changes from then on, it's unpingable even when left for > a few minutes (so even then the network isn't initialised). Selecting > back to acpi only restored service. > > Do you need me to connect it via serial? I didn't do that because > although it is usually booted headless, it does have x/xenocara installed > (and working). So was expecting hdmi output like with acpi.
In device tree mode serial output will be the default. You can switch to HDMI (what we call glass console) by typing set tty fb0 at the boot> prompt. You can make this permanent by adding this command to a /etc/boot.conf file. Also note that support for the temperature sensor in ACPI mode was added recently, after the 6.8 release. Cheers, Mark
