You will need to have the filter fire in phase 1 instead of normal push fields in a later phase.
I believe it's `! added to the end of the filter name -Geoff -----Original Message----- >From: Alfredo Avendano <[EMAIL PROTECTED]> >Sent: Oct 26, 2006 9:29 AM >To: [email protected] >Subject: Re: Problem with Push Fields in a Table Loop > >Alex, > >I experienced a similar problem before, I believe I >solved it creating a set field action to pass the >column values to a display only field, and then use >the display only fields on the push field action. > >Alfredo > >--- Alex Bredariol <[EMAIL PROTECTED]> wrote: > >> A filter "A" calls a Filter Guide "B" looping a >> table. >> This Filter Guide "B" contains a filter that should >> execute a push fields in >> another form. >> >> But there's a problem: it always push the same data. >> It's not a mistake with >> the Table I'm looping, because I tested using set >> fields and displayed >> messages with the value and both work. >> >> Does someone know what may be happening? >> >> Thanks >> >> Alex Grilo >> >> >_______________________________________________________________________________ >> UNSUBSCRIBE or access ARSlist Archives at >> http://www.wwrug.org >> > > >__________________________________________________ >Do You Yahoo!? >Tired of spam? Yahoo! Mail has the best spam protection around >http://mail.yahoo.com > >_______________________________________________________________________________ >UNSUBSCRIBE or access ARSlist Archives at http://www.wwrug.org _______________________________________________________________________________ UNSUBSCRIBE or access ARSlist Archives at http://www.wwrug.org
