Kyle, I think you will find that this special run process will land the user in the "Report" form/window with a list of reports that the user can use. I have yet to find a way to "Run" a report that way.
However, you can use the Window Open action to run a report. I think if you get tricky enough with the advanced mode and your design for your table field then I think you can get the Window Open action to point at the same data set that the Table Field does with a little effort. With a little more effort I think you could even only run the report on the rows that the user selected too. -- Carey Matthew Black Remedy Skilled Professional (RSP) ARS = Action Request System(Remedy) Love, then teach Solution = People + Process + Tools Fast, Accurate, Cheap.... Pick two. On 3/28/07, Kyle Whitley <[EMAIL PROTECTED]> wrote:
I was looking for a way to run a report off of selections made in a table field and ran across the following Run Process command "PERFORM-ACTION-TABLE-REPORT <table_field_ID>". I have a few questions: - Has anyone used this before? - How do you specify which report should be run? - Where does the output go? Thanks Kyle -- Kyle Whitley IT System Support Professional Office of Information and Instructional Technology (OIIT) Board of Regents of the University System of Georgia
_______________________________________________________________________________ UNSUBSCRIBE or access ARSlist Archives at www.arslist.org ARSlist:"Where the Answers Are"
