Michael Thomas - Mathbox wrote: > > Following my post about "Could not open connection to the > host,on port 25: > Connect failed" on Version 1.4.5, I loaded the latest version > I have (1.4.5 > RC13) and started testing. > > All tests were conducted under zero load. The test is to > repeatedly, manually telnet to ASSP on port 25 and then break > the connection after receiving the ASSP HELO. Failure was > recognized if I could not connect or if I lost a partial > connection (connected, but no response from ASSP). It was > rather easy to achieve failure within 5 or 6 attempts, > sometimes only 3 or 4 attempts. > > As each version failed, I rolled back to the next most > previous version that I had on hand. All of them failed until > I got back to version 1.2.5 (2). > Version 1.2.5 (2) does not break. I then set up a monitor > connection. It still did not break. > > Versions tested include: > 1.4.5 RC 8 and 11 > 1.4.3 > 1.4.1.1.47 > 1.4.1.1 > 1.3.8 > 1.3.3 > 1.3.0 > 1.2.5 (2) > > I am guessing here, but I think something changed in the flow > that affected connection accept();
Are you sure you're not running into the Frequency limit under IP Blocking? By default, it gives a score of 150. It seems to me that Frequency limiting was added around the time of 1.3.0ish. --Brett ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Assp-test mailing list Assp-test@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/assp-test
