|
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of A. Sila Sent: Monday, April 04, 2005 8:31 PM To: [email protected] Subject: [Asterisk-bsd] Digium TDM21B and Zaptel Hi All,
I am facing a weird situation while trying
to get a newly from Digium acquired TDM21B card up and running. I am wondering
whether anyone on this list experienced the same thing and could help me
out.
Here is the situation:
a). Without the TDM installed the system works
fine, w/o any error messages;
b). Once the TDM card installed and duly
configured as per Digium's instructions (see below, e), Asterisk stops working,
the system reports the following error messages (part of the message):
Apr 1 03:27:03 WARNING[517]: Ignoring
signaling Apr 1 03:27:03 ERROR[517]: Signalling
requested is FXO Kewlstart but line is in FXS Kewlstart
signalling Apr 1 03:27:03 ERROR[517]: Unable to
register channel '4' Apr 1 03:27:03 WARNING[517]: chan_zap.so:
load_module failed, returning -1 Apr 1 03:27:03 WARNING[517]: Loading module
chan_zap.so failed!
-
FreeBSD 5.3; Asterisk 1.0.6-BRIstuffed-0.2.0.RC7j - Ports installation of Asterisk, Zaptel and Zapata using latest cvs version e).
The card installation was done following the instructions in http://www.digium.com/downloads/tdm_inst.pdf; Its
configuration was done according to the instruction in http://www.digium.com/index.php?menu=configuration#TDM2XB That is correct. "
A) | Add these
lines to /etc/zaptel.conf |
fxoks=1-2 # Make sure that the FXS(green) modules are closest to the bracket if you are looking at the side of the card with all of the electronic components. fxsks=3-4 # This is for the FXO module(s) because it uses FXS signalling, if you only have one FXO module then remove the '-4' defaultzone=us loadzone=us "
You only have 1 FXO Module. at least by the designation of TDM21B, if you added a second FXO module then that is different. Confirm how many modules are on the card by looking at it, if it is configured as suggested you have 3 of the four modules. You would only set fxsks=3
Hope this helps.
-Andrew |
_______________________________________________ Asterisk-BSD mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-bsd
