Hello fellow asteriskers (can i say that?)
My name is Brian. I'm looking to setup asterisk on a 1.1GB machine with 256MB of RAM Using an X100P wildcard (clone? i ordered the devices on EBay). When up and running I would like to use this machine with my Vonage VOIP connection. To support my young educational non-profit org -> shameless plug www.parkday.org.
I have been reading about asterisk for about one month now. I have purchased the O'reilly Book "Asterisk: The Future of Telephony" and have read about half of it.
First attempt at running asterisk on FreeBSD 6.0 RELEASE resulted in a core dump anytime I tried to run asterisk from the cmd line. Poking around I read somewhere?? that asterisk is not quite ready for 6.0 RELEASE just yet. Upon reading this I went and re-installed the OS with version 5.4 RELEASE.
First thing I did after re-installing my OS is re-copiled my kernel to remove all extraneous devices, everything is ok so far.
Now I downloaded all the asterisk (main sounds addons) source code from digium ftp site placed them in /usr/src.
Then I went into the /usr/ports and installed bison gmake and libpri.
>From there went to the zaptel ports directory to install the zaptel drivers from there... Here's where things start to get sticky?
patrick# make clean && make && make install
install seemed to be completed ok
patrick# /usr/local/etc/rc.d/zaptel.sh start
kldload: can't load %%PREFIX%%/lib/zaptel/zaptel
.ko: No such file or directory
Here's where I'm lost? On my first attempt using 6.0-RELEASE zaptel started up fine at boot time and even recognized both X100P cards?
So I wondered . . . Do I need to install asterisk before I tried to run the zaptel drivers? So I went into /usr/src/asterisk-1.0.10 and ran:
patrick# gmake clean && gmake && gmake install
All seemed to go well there, So I ran:
patrick# /usr/local/etc/rc.d/zaptel.sh start
Which resulted in the same error as before. So now I'm really stumped!
Any assistance with my conundrum would be greatly appreciated.
Thanx
bb
Here's where I'm lost? On my first attempt using 6.0-RELEASE zaptel started up fine at boot time and even recognized both X100P cards?
So I wondered . . . Do I need to install asterisk before I tried to run the zaptel drivers? So I went into /usr/src/asterisk-1.0.10 and ran:
patrick# gmake clean && gmake && gmake install
All seemed to go well there, So I ran:
patrick# /usr/local/etc/rc.d/zaptel.sh start
Which resulted in the same error as before. So now I'm really stumped!
Any assistance with my conundrum would be greatly appreciated.
Thanx
bb
#-#-#-#-#
_______________________________________________ Asterisk-BSD mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-bsd
