If I leave the zaptel.conf's content as:
span=1,0,0,ccs,hdb3
span=2,0,0,ccs,hdb3
then the RED warning will appear.
I I connect a "loop back" line into span1's RJ45 socket,then the warning become RED/YELLOW.
if I config the span1 as PRI_NET and span2 as PRI_CPE and connect them with a cable ,after I run the asterisk with -vvvvc,I could see the Tor channels are started. But when I dial the extenion based on zaptel's channel,I always got the information that the channel is busy.
(if I change the chip and crystal to T1's,then all is OK!)
Regards
john
Steve Underwood writes:
[EMAIL PROTECTED] wrote:
Hi,Steve, My ISA E1 card does not work yet. I would like to know if there are other difference bettween then two kind of ISA card?
The crystals, the framer chips and the jumpers are the only differences.
What are the symptons of it not working?
Regards,
Steve
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
