Configure the span 1 as nethdlc=1-31 You have to have HDLC enabled in your kernel. Then compile zaptel/sethdlc (in zaptel "make sethdlc") and then ztcfg -vv sethdlc hdlc0 mode hdlc (or mode cisco) ifconfig hdlc ip_address network network_address
that's it! Now you have IP over HDLC/CISCO HDLC. regards Martin On Thu, 20 Mar 2003, David Luyens wrote: > Thanks Martin, could you point me into the direction on how to do this? > > David > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Martin Pycko > Sent: Thursday, March 20, 2003 7:10 PM > To: [EMAIL PROTECTED] > Subject: Re: [Asterisk-Users] Use 1 port of an E400P as IP connection > > > Sure. You configure it as HDLC or CISCO HDLC and you have > hdlc0 interface to send data. > > regards > Martin > > On Thu, 20 Mar 2003, David Luyens wrote: > > > Hi, > > > > I would like to use * as a compression box. > > Between 2 sites I have an E1 leased line. > > > > So would it be possible to use 1 port of an E400P card to route my IP > > IAX calls over in order to cut the ip router out of the picture? > > > > David > > > > > > _______________________________________________ > > Asterisk-Users mailing list > > [EMAIL PROTECTED] > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
