After days of searching, I found H600-307. Searching this yeilded a pinout - ta da!
47 LI (High) 22 LI 48 LO 23 LO (High) (there is also a loopback pair - but I won't bore you with this) I get: I=In, O=Out Does anyone know if High (telephone lingo) corresponds to tip or ring? On our normal RJ45 do we transmit (Out) on 1&2 or 4&5? John -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of John Harragin Sent: Friday, April 04, 2003 2:25 PM To: Asterisk Subject: [Asterisk-Users] AT&T T1 Cable Needed! Hi, I just got a T1 interface for a AT&T (became Lucent) System75 (uses same cards as Definity). I would take a crack at making a cable but can't determine the pinout for a cable and it is not apparent from the board. Asking you guys makes sense as one of you may have one of these systems. The cable has a amphenol male D50 connector on one end and probably a rj45 on the other. I also don't know if any other devices are needed between the System75 and asterisk The DS1 Tie Trunk card is a TN722B. Any information would be helpful. Thanks, John This e-mail was scanned and found clean by Monroe-Woodbury CSD Antivirus. _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users This e-mail was scanned and found clean by Monroe-Woodbury CSD Antivirus. This e-mail was scanned and found clean by Monroe-Woodbury CSD Antivirus. _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
