Check if you can enable "remote disconnection supervision" with your PBX. If not you may try using the software detection when you specify
callprogress=yes or busydetect=yes before the definition of your channel in zapata.conf Martin On Wed, 28 May 2003, Manuel Marin Garcia wrote: > Asterisk is running with a X100P card. When I connect a CO line to the > X100P card, the busy tone is detected and * disconnect the channel without > any problem. The disconnection problem occurs when instead of a CO line I > connect an analog extension from a Meridian Option 11 PBX. When The caller > hang-up, the X100P only receives a Dial tone no a busy tone. I would like to > know if there is an option to configure X100P in order that after receiving > a Dial tone for a specific period of time automatically disconnect the > channel. > > Thanks > > > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
