Hi there I have some problems in setting up a connection between * and a Wellgate 1501 (1FXS). Either I can dial from * to my Wellgate or I can dial from the Wellgate to *.
On the Wellgate you have to setup both "Line number" (which is the number it answers) and "Line account" (which is the account it registers as). Should I expect any problems if these are set the same? Below are two examples of sip.conf, the first I can call * -> Wellgate the second is Wellgate -> *. #1 -------- sip.conf -------- [43300634] type=friend secret=1234 host=dynamic dtmfmode=rfc2833 defaultip=10.1.1.3 -------- end of sip.conf -------- With the above config I can call from * to Wellgate, but if I try to call from Wellgate to * I get som wierd warning messages in * and the log on the Wellgate shows it doesn't get past inviting. Asterisk: WARNING[65545]: File chan_sip.c, Line 432 (retrans_pkt): Maximum retries exceeded on call [EMAIL PROTECTED] for seqno 1 (Response) WARNING[65545]: File chan_sip.c, Line 2220 (__transmit_response): Unable to determine sequence number from '' Wellgate: 1-RVSIP_CALL_LEG_STATE_INVITING The funny thing is that if I comment out the above section and reload *, I now can call from Wellgate to * but not the other way around of course as the Wellgate isn't registered anymore. Are there anything wrong with the above setup or should it work as expected? #2 -------- sip.conf -------- [433006341] type=friend secret=1234 username=43300634 host=dynamic dtmfmode=rfc2833 defaultip=10.1.1.3 -------- end of sip.conf -------- With this config I can call both ways unless the Wellgate is registered with *, then i can't call from * to Wellgate. I think its because it doesn't use the username value when it is registered, which means it dials 433006341. Please tell me what I have misunderstood or dont wrong? regards Mickey Binder _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
