What if I have two sip phones and a call arrives for #1 from my zap interface, should I be able to do a pickup from #2 as well?
And how would my configuration look, do I have to specify anything in sip.conf or is it enough to specify it in zapata.conf? > -----Original Message----- > From: Martin Pycko [mailto:[EMAIL PROTECTED] > Sent: 4. september 2003 21:08 > To: Asterisk maillist (E-mail) > Subject: Re: [Asterisk-Users] I don't think I understand "Call pickup" > > > Lets say that you have two phones: Zap/1 and Zap/2 > > and there comes a call over IAX to Zap/1 > since channel 1 is in the callgroup 1 > and channel 2 is in the pickupgroup 1 channel 2 can dial *8 > and pick up > the call that comes to channel 1. > > Martin > > On Thu, 4 Sep 2003, Mickey Binder wrote: > > > I must be getting something wrong about this call pickup. > > > > In zapata.conf I have just the default callgroup=1 and > pickupgroup=1. If I > > call from my mobile to * and then try to dial *8 from any > other phone than > > the one which is ringing I just get a "Nothing to pick up" > answer on my * > > console. > > > > I also have experimented with those parameters in sip.conf > but are not aware > > of exactly where to use them. Can those be put under the > [general] section > > or should they go under each user definition? > > > > regards > > Mickey Binder > > > > > > _______________________________________________ > > Asterisk-Users mailing list > > [EMAIL PROTECTED] > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
