Re: [Asterisk-Users] TDM400P Problem

[Steve Totaro]

I had the same thing and just figured it out yesterday!   the problem is that the tdm400p is failing calibration.  type "dmesg" and it will tell you.    uncomment in zaptel/Makefile KFLAGS+=-DNO_CALIBRATION in the source code and "make clean install"   It worked for me but I wonder if there is a bad batch of cards?  I was in the "backordered till Sept 2nd batch"  I am assuming its not good to fail calibration?   Steve Totaro ----- Original Message ----- From: How Peng Kaiam To: [EMAIL PROTECTED] Sent: Thursday, September 11, 2003 9:52 AM Subject: [Asterisk-Users] TDM400P Problem Hi,   Just received the TDM400P and X100P. PC can detect the X100P, but not the TDM400P. Tried to load the wcfxs module, reported: modprobe wcfxs > /lib/modules/2.4.20-20.9/misc/wcfxs.o: init_module: No such device > Hint: insmod errors can be caused by incorrect module parameters, including > invalid IO or IRQ parameters. >       You may find more information in syslog or the output from dmesg > /lib/modules/2.4.20-20.9/misc/wcfxs.o: insmod > /lib/modules/2.4.20-20.9/misc/wcfxs.o failed > /lib/modules/2.4.20-20.9/misc/wcfxs.o: insmod wcfxs failed Any advise. Thanks.