My question: How do
I configure AAH via AMP to make a connection through our legacy PBX to the
PSTN?
Details:
We're trying out
Asterisk through Asterisk @ Home.
Our legacy PBX
has a modem type dial tone port that we hooked a Digium FXO
to.
Now I can
dial from the XTEN client on my computer to any legacy PBX
extension.
If I connect a
regular phone to the modem dial tone port, I can dial 9 to get an outside
line.
Replacing the phone
line back to the Digium FXO port, I cannot dial 9 and the phone number to route
my call to the PSTN through the legacy PBX.
Looking at the AMP
(Asterisk Management Portal)=>Outbound Route, I have two routes
created:
PBX=>to several
legacy PBX extensions: 250, 270, 280 (these are the dial
patterns)
9_outside=>to the
default dial pattern included with AAH: 9|. (that is the sole dial
pattern)
I wonder if the
digits get dialed too fast to connect to the PSTN? Can I put a pause in
somehow?
I can see that
Asterisk does grab the outside line.
When I dial, I get
the following message, which I think is coming from the
PSTN:
"We're sorry your
call did not go through, Will you please hang up and try your call again. This
is a recording."
Any ideas
anyone?
Thanks,
--Bill
Phoenix,
AZ
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
