If that is the case, then why on one port FXO (WCFXO) it work different. If there is no dial tone on this card system will play "All circuit are busy now" and if a second card is installed the call will rollover to the second card automatically. My concern is on a 4 line system if the first line loose dial tone nobody can make outgoing calls unless first channel is busy.
----- Original Message ----- From: "Rich Adamson" <[EMAIL PROTECTED]> To: "Asterisk Users Mailing List - Non-Commercial Discussion" <[email protected]> Sent: Sunday, July 10, 2005 1:42 PM Subject: Re: [Asterisk-Users] TDM04B Outbound calls > > > I just install a Digium TDM04B card. I created 4 separate Zap channels and one outbound > routing containing zap channels > > from 1 to 4. If a phone line is plug in Zap/1 then works fine, but if I unplug phone line from > Zap/1 (simulating fail) the system > > keep dialing out on Zap/1, even with no dial tone; Only if Zap/1 is busy it will use Zap/2. > > There is any work around or different setting to avoid this situation? > > I don't believe asterisk has any code to detect whether a pstn > line is plugged in or not. The chipset on the TDM-fxo modules do > support that function, but the drivers don't do anything with it > right now. > > Mark added code for that about a year ago, but commented it out within > a day or two as it caused problems for some folks. Don't know if that > code remains in the drivers as yet or not. > > > _______________________________________________ > Asterisk-Users mailing list > [email protected] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
