Steven Thanks for the help.
After rebooting the box, * gives me an error claiming that * is already running on /var/run/asterisk.ctl Before I rebooted I ensured that there was no asterisk.pid or asterisk.ctl. After I get the above mentioned message if I then run asterisk again I get the "Unable to open...device busy" (with or without the asterisk.pid and/or asterisk.ctl) Any help would be greatly appreciated. Rgds Dan ----- Original Message ----- From: "Steven Critchfield" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, September 17, 2003 12:02 AM Subject: Re: [Asterisk-Users] problem loading chan_iax2.so and chan_zap.sofrom latest CVS > On Tue, 2003-09-16 at 20:27, Dan Fernandez wrote: > > I just updated to the new CVS and now I am getting the following error > > from chan_zap (modprobe wcfxo works fine): > > > > WARNING[16384]: File chan_zap.c, Line 577 (zt_open): Unable to > > specify channel 1: Device or resource busy > > <snip> > > WARNING........:Unable to bind to 0.0.0.0 port 4569: Address already > > in use > > This looks rather obvious to me that you may not have stopped the > previous asterisk install. Either that or you have a kernel problem and > (oddly) need to reboot to free the port and the device handles. > > -- > Steven Critchfield <[EMAIL PROTECTED]> > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
