Would appreciate your answer. is it related to span in zaptel.conf? Michael
---------- Forwarded message ---------- From: Michael Jia <[EMAIL PROTECTED]> Date: Jul 26, 2005 1:26 AM Subject: Re: why zap call transfer fails? To: [email protected] Some further observation. Using the following config, I can dial 8 , reach the outbound line and get a dial tone without any problem. Then I can dial any number from that point on. exten => 8,1,Answer exten => 8,2,Dial(Zap/4/) exten => 8,3,Hangup It looks more to me a timing issue, is Asterisk sending the number to SP too quick or too slow? How do I config to ajust to that? Can anyone in the list share some light? Thanks a lot. Michael On 7/26/05, Michael Jia <[EMAIL PROTECTED]> wrote: > I tried a little more with following extension.conf > > ;dial out > ignorepat => 9 > exten => _9.,1,Answer > exten => _9.,2,Dial(Zap/4/${EXTEN:1}) > > exten => 100,1,Answer > exten => 100,2,Dial(Zap/4/2197723) > > dial 100 works fine, my other phone can receive the call. > but dial 92197723 doesn't work. In theory, they should be same. > I even notice in console, asterisk prints same log messages. But the latter > just hangs after > -- Attempting native bridge of Zap/1-1 and Zap/4-1 > and eventually hungup. > > Why? > > Thanks > Michael > > On 7/25/05, Michael Jia <[EMAIL PROTECTED]> wrote: > > Hi, > > > > I am configuring Asterisk with TDM400 card with 1 FXS and 1 FXO > > module. My first goal is to allow phones to be able to call out > > through the asterisk PBX. > > > > After channels and dial plans setup, Zap/1 connect to phone and Zap/4 > > connect to provider , when I dial the phone, the following message > > shows in the asterisk console > > > > ------------------ > > Starting simple switch on 'Zap/1-1' > > -- Executing Dial("Zap/1-1", "Zap/4/9999999") in new stack > > -- Called 4/9999999 > > -- Zap/4-1 answered Zap/1-1 > > -- Attempting native bridge of Zap/1-1 and Zap/4-1 > > -- Hungup 'Zap/4-1' > > ----------------- > > However, there is only 1 ringtone in my phone, and it becomes silent > > and eventually the call was dropped. > > > > But reversely, if i dial my home number from a different phone, i can > > reach the PBX, and then by dialing an extension, i can ring the local > > phone without any problem. > > > > I only have problem dialing out. What could be the reason? > > > > Thanks a lot. > > Michael > > > _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
