Yes it does apply. Near the top of your sip.cfg file, you should have lines
like this:
<alertInfo voIpProt.SIP.alertInfo.1.value="ring-answer"
voIpProt.SIP.alertInfo.1.class="4"/>
<alertInfo voIpProt.SIP.alertInfo.2.value="internal"
voIpProt.SIP.alertInfo.2.class="5"/>
<alertInfo voIpProt.SIP.alertInfo.3.value="doorphone"
voIpProt.SIP.alertInfo.3.class="6"/>
(I have a few here for auto-answer, internal extension ring cadence, and a
Zap doorphone alert)
You will also have something like these toward the bottom of sip.cfg under
<ringType>
<RING_ANSWER se.rt.4.name="Ring Answer" se.rt.4.type="ring-answer"
se.rt.4.timeout="2000" se.rt.4.ringer="7"/>
<INTERNAL se.rt.5.name="Internal" se.rt.5.type="ring" se.rt.5.ringer="3"/>
<DOORPHONE se.rt.6.name="Doorphone" se.rt.6.type="ring"
se.rt.6.ringer="11"/>
Notice the connection between the class=4 on ring-answer above and below.
Duplicate these lines if you don't have them. Place them within the
<SIP></SIP> section and the <ringType> sections respectively. Pick your
ringer values based on the ones on the IP300 menu, which gives you chirps,
stutters, and trills etc.
Whatever value you have assigned (i.e. doorphone) is the value you must have
set in the _ALERT_INFO variable when you make the Dial(SIP) command:
[doorphone]
exten => s,1,Answer ;DOORPHONE IS CALLING
exten => s,2,SetCIDName(Doorphone 1)
exten => s,3,SetCIDNum(400)
exten => s,4,SetVar(_ALERT_INFO=doorphone) ;SET ALERT-INFO TO POLYCOMS
exten => s,5,Monitor(gsm,doorphone-${TIMESTAMP},m) ;RECORD THE DOORPHONE
CALL
exten => s,6,Dial(SIP/101&SIP/102&SIP/104&SIP/201&SIP/203&Zap/2r3&Zap/3,22)
;RING SOME PHONES
exten => s,7,Playback(nobody-but-chickens) ; NOBODY'S HOME
exten => s,8,Hangup
Note that you need the first underscore for ALERT_INFO if you are using
CVS-HEAD.
Hope that helps!
Chris Coulthurst
[EMAIL PROTECTED]
----- Original Message -----
From: "David Koski" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, August 04, 2005 10:00 PM
Subject: [Asterisk-Users] PolyCom SoundPoint 300 and distinctive ring
I am looking for clues on how to configure distinctive ring for a PolyCom
SoundPoint
300. Does ALERT_INFO apply? If so, how?
Thanks,
David Koski
[EMAIL PROTECTED]
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
