> I've got the latest zaptel and cvs asterisk software loaded on my phone > server running FC3. And yes, It's fully updated and udev is setup > correctly. I've got a TDM400P with one FXS and one FXO module > installed. When I load zaptel and wctdm and run ztcfg -vvv, I get this: > > [EMAIL PROTECTED] ~]# ztcfg -vvv > ZT_CHANCONFIG failed on channel 1: No such device or address (6) > > Zaptel Configuration > ====================== > > > Channel map: > > Channel 01: FXO Kewlstart (Default) (Slaves: 01) > Channel 02: FXS Kewlstart (Default) (Slaves: 02) > > 2 channels configured. > > Regardless of my configuration, it should show up in ztcfg, right? > Here's my:
I'm not sure I understand your question. You ran ztcfg and it told you channel 1 is your fxs (phone) port, and channel 2 is your pstn port. Why the question "...it should show up in ztcfg, right"? > ****** zaptel.conf ******** > > loadzone = us > defaultzone = us > fxoks=1 > fxsks=2 > > ****** zapata.conf ******** > [trunkgroups] > [channels] > language=en > context=default > switchtype=national > signalling=fxo_ks > rxwink=300 ; Atlas seems to use long (250ms) winks > usecallerid=yes > hidecallerid=no > callwaiting=no > usecallingpres=yes > callwaitingcallerid=no > threewaycalling=no > transfer=yes > canpark=yes > cancallforward=yes > callreturn=yes > mailbox=2500 > echocancel=yes > echocancelwhenbridged=yes > rxgain=0.0 > txgain=0.0 > group=1 > callgroup=1 > pickupgroup=1 > immediate=no > context=default > channel => 1 > context=incoming > signalling=fxs_ks > group=2 > channel => 2 > > Thanks for your help. Does asterisk start correctly? (You didn't mention that, but start it with 'asterisk -cvvvvvd' and scan back through the pages to see if it is complaining about anything. If it starts correctly, do a 'zap show status'. What does it say? Do a 'zap show channels'. What does it say? If the above looks correct, then you probably have an asterisk config problem. For example, several of the statements that you have shown in zapata.conf for channel 1 do not apply to fxs modules, and some don't even apply to the TDM card. Strip that down to minimal config statements and try again. - switchtype=national applies to T1 interfaces, not TDM analog ports - rxwink=300 applies to pstn trunks, not to fxs phone ports After stipping down the config to bare necessities, once you get it to work properly, then add "features" into the config. If you mistakenly plugged the pstn line into the fxs module, there is a very high probability the module is blown, particularily if the pstn line rang while it was plugged in. (If that's the case, call digium to see if they will warranty the module, or buy another one and be more carefull. _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
