To make sure no configuration issue, I only had one of them working at a time. After test on one of them, I swapped out with the other and rebooted. Both were detected as same. However, echo only happened on one but not the other. I know nothing about electronics. Layout of both cards looks almost the same. However, the card from www.broad-tel.com never have echo during several tests.
the one I got from somewhere else has echo issue. I bought the second one from www.broad-tel.com since they claimed their cards never have experienced echo problem. And it does in my case. How can I tell their firmware version if any? On 8/15/05, Mark Phillips <[EMAIL PROTECTED]> wrote: > Are these cards on the same line or are they on different lines. > > Assuming different lines, what happens when you swap the lines over? > Does the echo follow the line? > > Also, It seems that these cards can be modified to do a number of things > either in firmware or in hardware. Are they electronicly identical. If > so then are they the same firmware version? > > I'm just throwing them out there. > > I have the same problem and my cards identify themselves as different > manufacturers. I'm assuming that they have different firmware versions > from the OEM. > > Mark > > VoIP Newbie wrote: > > I have 2 OEM X100P. The one from www.broad-tel.com works fine.However, > > the other one has echo. Both use MD3200 chips. Any one knows why it is > > so?? > > > > On 8/13/05, Madhawa Jayanath <[EMAIL PROTECTED]> wrote: > > > >>Carlos Trallero wrote: > >> > >> > >>>Hello, > >>> > >>>I have asterisk running on Fedora Core 3 with a x100p > >>>(oem). After some time I got asterisk with some soft > >>>extensions working (u gotta love open source), but I'm > >>>stuck with outbound dialing. This is the diagnose: > >>> > >>>- detect 1 wcfxo channel. > >>>- when trying to make an outside call I get unable to > >>>create channel of type Zap. Everyone is busy/congested > >>>at this time > >>>- When I plug the x100p to the phone jack, the dial > >>>tone in all of my phones die. > >>> > >>>Because of the later I'm suspecting that there is > >>>some problem with the signaling or voltage detection. > >>> > >>>My PSTN line is actually from a VoIP modem that runs > >>>over the Cablevision network (known as Optimum Voice). > >>> > >>>Thanks everyone. > >>>Carlos > >>> > >>> > >>> > >>> > >>> > >>>__________________________________ > >>>Do you Yahoo!? > >>>Yahoo! Mail - Find what you need with new enhanced search. > >>>http://info.mail.yahoo.com/mail_250 > >>>_______________________________________________ > >>>Asterisk-Users mailing list > >>>[email protected] > >>>http://lists.digium.com/mailman/listinfo/asterisk-users > >>>To UNSUBSCRIBE or update options visit: > >>> http://lists.digium.com/mailman/listinfo/asterisk-users > >>> > >>> > >>> > >>> > >>> > >> > >>Hello, > >>Where did u get that OEM X100P? Is it MD3200 chip? > >> > >>Cheers, > >>~Madhawa > >> > >> > >>_______________________________________________ > >>Asterisk-Users mailing list > >>[email protected] > >>http://lists.digium.com/mailman/listinfo/asterisk-users > >>To UNSUBSCRIBE or update options visit: > >> http://lists.digium.com/mailman/listinfo/asterisk-users > >> > > > > _______________________________________________ > > Asterisk-Users mailing list > > [email protected] > > http://lists.digium.com/mailman/listinfo/asterisk-users > > To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > -- > > Mark, G7LTT/KC2ENI > Randolph, NJ > http://www.g7ltt.com > _______________________________________________ > Asterisk-Users mailing list > [email protected] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
