Hello, In my quest to figure out the source of the random echo on our shiny new asterisk install, I have been using ztmonitor on the TDM400p channels for the good part of today.
I have 2 TDM400p cards with 8 FXO modules and 6 pots lines connected to them (last 2 channels are unused but configured in zaptel). Even when the lines are onhook, the Tx values settle down to 0 but the Rx values still jump up and down. For some lines the values vary around 440, for others around 250 and for one of the unused FXO ports, its around 97 all the time. With txgain/rxgain set to 0.0, call volumes were considerably low. Hence, I have txgain set to 1.0 and rxgain set to 6.0. I was wondering if the ztmonitor Rx: values were normal for what they show, or are they too supposed to settle down to 0. If this is not normal, does this indicate any problems with the pots lines? -- VaibhaV _______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com -- Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
