hi,
I'm trying to configure my newly acquired TE410P card to work as 4 E1 spans. This is
supposed to be a drop-in replacement to the earlier E100P card. However, on loading the
zaptel module it gets configured as T1 spans basically doing a 'cat' on /proc/zaptel/1 thru 4,
it shows 24 channels per span. After this ztcfg fails saying 'ZT_CHANCONFIG failed for channel 97'.
This is obviously because Quad T1 has only 96 channels. The question is how do i get the zaptel module
to recognize the card as Quad E1 and not Quad T1.
My current /etc/zaptel.conf goes as follows:
There's jumpers on the board that are clearly marked.
Jumper on = E1 Jumper Off = T1
Hope this helps..
-- Richard
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
